When shopping for jewelry online, specially rings, it's essential that you know your accurate size so it fits like a charm.

1. You can measure your finger with a strip of paper or string.

STEP 1: Start by cutting out a strip of paper that is approximately 3/4-inch wide and 4 inches long.

STEP 2: Wrap the paper around the base of the intended finger, and then mark where the paper overlaps. The length of the paper you measured in millimeters is the circumference of your finger.

STEP 3: After finding this measurement, use our conversion chart to find the corresponding ring size. If the size of your finger below the knuckle drastically differs in size from the knuckle itself, measure your knuckle as well and choose a size that falls more in the middle of these two measurements.

 

2. You can measure a ring you already have by using a ruler

STEP 1: Use a ruler to measure the inside diameter of this ring straight across the inside of the ring from edge to edge.

Take the diameter measurement in millimeters.

STEP 2: Use our measurement-conversion chart to find your ring size.

 

GET YOUR MESUREMENTS RIGHT

The same Technic can be used to measure bracelets.

STEP 1: You can print the ruler below in paper with 11 inches or use a string and a ruler.

Cut the measuring strip. It should be the entire length.

STEP 2: Wrap the strip around the widest part of the hand you will be wearing the bracelet on as per image below.

Pull it snug but not tight.

STEP 3: Choose the size where the ends of the strip overlap.

If you are between sizes, decide whether you prefer to wear your bangles tighter and squeeze it over your hand, or if you prefer them looser and easier to slide on.

 

Necklaces are easier to measure, find below in the picture what length is your favorite.

Now that you know your sizes, happy shopping!

xx

Paola Vaz

 

paolavaz@olivatelie.com 

Sydney, NSW Australia

© 2019 by Oliv Atelie 

All rights reserved 

  • Pinterest
  • Instagram
  • Facebook